Saturday, March 28, 2015

SERVICE MODE - SAMSUNG LE32A65 - LE37A65 - LE40A65 - LE46A65 - LE52A65

SAMSUNG LE32A65 - LE37A65  - LE40A65  - LE46A65 - LE52A65


SERVICE MODE 

Entering Factory Mode
To enter ‘Service Mode’ Press the remote -control keys in this sequence :
- If you do not have Factory remote – control

INFO > MENU > MUTE > Power on

- If you have Factory remote – control

PICTURE ON > DISPLAY > FACTORY

The buttons are active in the service mode.
1. Remote - Control Key : Power, Arrow Up, Arrow Down, Arrow Left Arrow Right, Menu, Enter, Number Key(0~9)
2. Function - Control Key : Power, CH +, CH -, VOL +, VOL -, Menu, TV/VIDEO(Enter).
Panel Check
You have to check Panel Maker Because of different adjustments as follows.
First of all, Check the label rating!
1) Label Rating File
- LCD PANEL MARK
A:ACER(AUO) S : SEC C : CMO
* If not printed you could consider S(sec) panel mark
Factory Data
1. Option Table(Service)
2. WB Adjust
3. Information
CheckSum
T-PRLPEUMD-**** (Main Micom Ver.)
T-PERLDEUC-**** (DTV SW Ver.)
T-PRLPEUS-**** (Sub Micom Ver.)
Month/Day/Year
Hour/Min./Sec.
4. Advanced Menu

White Ratio (Balance) Adjustment
1. You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance).
2. Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS, Component 1 and HDMI 1 modes.
3. The optimal values for each mode are confiured by default. (Refer to Table 1, 2) It varies with Panel’s size and Specifiation..
- Equipment : CS-210
- Pattern: MIK K-7256 #92 “Flat W/B Pattern” as standard
- Use other equipment only after comparing the result with that of the Master equipment.
- Set Aging time : 60min